To change IML Clicks and a USB receiver from static addressing mode to dynamic addressing mode;
- Insert the USB Receiver
- Open IML Click System Manager
- Make sure the USB receiver is set to Static address mode
- In the Keypad setup section set the channel number to '0'
- Set the next Click# to 0
- Press Start
- A pop up message appears giving you instructions on what to do and also a warning to make sure you are aware that you will be altering the configuration of your IML Clicks. Press Yes
- On the IML Click press and hold the Link button and the '2' button together
- The LED on the IML Click device will flash
- Press the send button on the IML Click
- You will get a green confirmation light on the IML Click LED
- Repeat steps 8-11 for all of the IML Clicks you wish to set to dynamic mode
- When you have finished press stop
- Press the Clear responses button
- Under the USB Receiver settings press configure and change the receiver address mode to dynamic and set the channel number of the receiver
- Your clicks are now set into dynamic mode, the next step is to connect them with to the channel of the USB Receiver
Connecting your dynamic addressing IML Clicks to a dynamic USB Receiver
- On the IML Click press link followed by the 2 digit channel number of the USB reveiver you wish to connect to followed by the 'link' button (if the USB Receiver has a single digit channel number you must enter a 0 followed by the channel number e.g. 02)
Reviewed and Approved by Product Team
Comments
0 comments
Please sign in to leave a comment.